How to Give a name / label to FXO ports ?

susanto.liu · ‎07-12-2009

FXO port 0/0/0, label as â€œA1â€

FXO port 0/0/1, label as â€œA2â€

FXO port 0/0/2, label as â€œA3â€

So when incoming call from FXO port 0/0/0 ringing in IP Phone, in IP Phone displayed â€œA1â€

When incoming call from FXO port 0/0/1 ringing in IP Phone, in IP Phone displayed â€œA2â€

Using Call Manager v.7.0

How to configure this ? (MGCP & H.323)

Please help me.

paolo bevilacqua · ‎07-13-2009

Use "station-id name".

susanto.liu · ‎07-13-2009

I have been try it and still not working. Any idea ?

paolo bevilacqua · ‎07-13-2009

Works with H.323. If you're using MGCP, I have no idea if and how it can be done.

susanto.liu · ‎07-13-2009

So, from You experience, from Router as VG connect to CUCM using H.323, which a station-id was configured in Router, will be shown on IP Phone display when incoming call ?

Thank's for You support.

James Hawkins · ‎07-13-2009

For MGCP just set the Display (Internal Caller ID) for the Directory Number within CallManager - just the same as any DN used by IP phones etc.

susanto.liu · ‎07-13-2009

are You sure? I think, it is caller ID of Extension, for extension call to extension. Not for caller ID of FXO.

paolo bevilacqua · ‎07-13-2009

It should, works with CME for example.