Switch Hyper Terminal Problem

Answered Question
Jul 12th, 2009
User Badges:

when we want to connect switch though Hyper Terminal it showing following problem:-


% No defaulting allowed


Enter interface name used to connect to the management network from the above interface summary:




Correct Answer by Giuseppe Larosa about 8 years 2 weeks ago

Hello Ravi,

the switch has an empty configuration and you are during initial setup where it puts you questions like the one you have reported.


This question asks what of the interfaces with an ip address has to be used to look for a default gateway/default route


you can skip all this and you can manually configure the device or you can take advantage of initial setup to have some parameters configured like hostname, ip addresses on interfaces and where to look for a default gateway/default route


Hope to help

Giuseppe


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Giuseppe Larosa Tue, 07/14/2009 - 06:01
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Ravi,

the switch has an empty configuration and you are during initial setup where it puts you questions like the one you have reported.


This question asks what of the interfaces with an ip address has to be used to look for a default gateway/default route


you can skip all this and you can manually configure the device or you can take advantage of initial setup to have some parameters configured like hostname, ip addresses on interfaces and where to look for a default gateway/default route


Hope to help

Giuseppe


Actions

This Discussion