07-13-2009 02:38 AM - edited 03-15-2019 06:56 PM
Dear All
Is there any way for implementing SRST on cisco H323 gateway instead of mgcp?
regards
07-13-2009 05:51 AM
Yes, the config is pretty much the same, this link should get you going:
http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00807f8b31.shtml
07-13-2009 05:52 AM
Yes, you can use SRST with an H.323 gateway. You would basically just need to configure phone support. See the following link.
This is assuming that you have proper dial peers in place. You would also need to consider how calls get routed to voicemail, AAs, etc. when SRST is active.
Hope this helps.
Brandon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide