mkodali Mon, 07/13/2009 - 11:19
User Badges:
  • Cisco Employee,

I assume you are trying to synchronize time with an ntp-server. This is how you can configure on sensor CLI :


sensor# configure terminal

sensor(config)# service host

sensor(config-hos)# ntp-option enable

sensor(config-hos-ena)# ntp-servers ip_address key-id key_ID


Later versions of the sensor software also support the unauthenticated option for time synchronization as


qsensor-204(config)# ser host

qsensor-204(config-hos)# ntp-option enabled-ntp-unauthenticated

qsensor-204(config-hos-ena)# ntp-server x.x.x.x



Actions

This Discussion