07-13-2009 09:59 PM - edited 03-04-2019 05:25 AM
Hi,dear all!
when I configurate the is-is,it show the error msg below:
one port is:%CLNS-3-BADPACKET: ISIS: LAN L2 hello, bad circuit type 0 from ca03.0b20.001c (FastEthernet1/1)
and the other port is:%CLNS-3-BADPACKET: ISIS: L2 CSNP, packet length 0 less than header length 33 from ca04.0b20.001d (FastEthernet1/0)
can anyone help me,and are there have doc to reference?
TKS...
Solved! Go to Solution.
07-14-2009 03:16 AM
Hello Bo,
it looks like one of the two routers is not running IS-IS correctly.
May you post the platform models and the IOS images you are using?
And eventually the parts of your configuration involved: interface config is-is process config of both nodes
Hope to help
Giuseppe
07-14-2009 03:16 AM
Hello Bo,
it looks like one of the two routers is not running IS-IS correctly.
May you post the platform models and the IOS images you are using?
And eventually the parts of your configuration involved: interface config is-is process config of both nodes
Hope to help
Giuseppe
07-15-2009 05:51 PM
Hi,Giuseppe!thanks your advice very much.i think you are right!
But i'm sorry,when i reset the dymimips and cofigurate the lab again.it's ok!and i haven't save the config.
So if i have any other issue,i will ask you!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: