Solved: FWSM IOS and ASDM files - Cisco Community

607

Views

0

Helpful

2

Replies

Hi!

How can I check file names of IOS and asdm loaded to FWSM? If I load new version of IOS, how can I erase the old one? Is it rewrited automaticly?

Command "dir flash" shows only that they presented on the flash.

dir flash:

Directory of flash:/

2 -rw- 3394960 <no date> asdm

1 -rw- 6062080 <no date> image

1 Accepted Solution

Accepted Solutions

You cannot. The flash can only take one image and one asdm unlike the PIX/ASA. When you issue

copy tftp flash:image

and

copy tftp flash:adsm

Both of them will get replaced. Upon reload

sh ver should tell you the image and the asdm version loaded.

Image upgrade/downgrade required a reload

asdm upgrade/downgrade does not require a reload.

View solution in original post

2 Replies 2

You cannot. The flash can only take one image and one asdm unlike the PIX/ASA. When you issue

copy tftp flash:image

and

copy tftp flash:adsm

Both of them will get replaced. Upon reload

sh ver should tell you the image and the asdm version loaded.

Image upgrade/downgrade required a reload

asdm upgrade/downgrade does not require a reload.

Thank you very much!

Review Cisco Networking products for a $25 gift card