Doubt about Hunt Group

Unanswered Question
Jul 15th, 2009
User Badges:
  • " /> Participante em Destaque,

    Prêmio"Escolha dos membros": novembro de 2014

Hi Guys,


I would like know if is possible to do the following configuration:

I Create a line group with 03 Directory Numbers. For example 1000, 1001 and 1002. The ring 1000 and not response, ring 1001 and not response too, ring 1002 and give busy tone. It's possible configure to return the call directory number 1000 again and repeat the process?


Thanks,

Wilson

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
Rob Huffman Wed, 07/15/2009 - 06:00
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Wilson,


You can set up a second Line Group that contains the same DN's/Members and link this second Group in the Hunt List.


Switch the rule on the first Line Group to, Try next Member;then try next Group in Hunt List


This will then cycle through the members a second time (I just tested this out in our lab a little while back) :)


Hope this helps!

Rob


wilsonsant Wed, 07/15/2009 - 06:09
User Badges:
  • " /> Participante em Destaque,

    Prêmio"Escolha dos membros": novembro de 2014

Hi Rob,


I am sorry, but, the Customer would like know if it's possible to do the same group. It's possible?


Thanks,


Wilson

Rob Huffman Wed, 07/15/2009 - 06:16
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Wilson,


Maybe I didn't explain this properly :)


This second Line group contains the "exact" same members, so it is the same group. This is the only way to cycle through these members a second time.


Hope this helps!

Rob

Actions

This Discussion