displaying errors on 1410 coax cable

Unanswered Question
Jul 15th, 2009
User Badges:

Is there a way to display counters -- including physical layer errors -- on the dual RG-6 cable linking the AP to its power injector?


Seems to me that 'sh int' displays counters for the dot11Radio0 interface (in the AP) and for the FastEthernet0 interface (the RJ-45 in the power injector) ... but I don't see anything corresponding to an interface to the coax cable running between the two. [BTW: does anyone know what protocol runs over the coax? Ethernet-over-shielded-RG, I suppose ... does this have a specific name?)


I believe that my coax has been damaged (water penetration), and I'm looking for a way to quantify physical layer problems with transmission over it.


--sk


Stuart Kendrick

FHCRC

Seattle, WA


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
dancampb Wed, 07/15/2009 - 10:57
User Badges:
  • Cisco Employee,

You could use the "show power-injector" command to look at the stats.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode