I have 1 AP 1130AG who's react strangly. It's in LWAP mode. If I connect it directly on a switch port, he get it's DHCP address and appears in WCS. But If I put the AP on another place we can't get it's IP adress. The only thing differ it's he pass thru a patch panel. The cable is good because if I install another 1130AP on the same place he get's his config and work normaly.
I try reseting all config with the mode button but it's doesn't change anything. More strange thing it's this AP already work on this place.
My WCS version is 220.127.116.11
My controller is on a 6509 chassis with Wism module WS-SVC-WISM-1-K9
The IOS of the AP 12.4-10b ja2
The Radio led is blinking amber
The Ethernet led is blinking green
The status led is blinking red and green
I've attached a captured when the AP boot