Omnipeek and Cisco AP

Unanswered Question
Jul 15th, 2009

Im trying to obtain data using an AP in sniffer and that data i would like to be send to remote PC using onmipeek .

i follow their instructions on the website but it dosn't work .

Any suggestion.

Thank you


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
dancampb Thu, 07/16/2009 - 05:27

To use Omnipeek you have to get some remote plugins from Wild Packets. You might want to make sure you have the right version.

Also make sure you disable IP-MAC address binding on the controller. This is a requirement.

There are multiple sniffers that will work with an AP in sniffer mode. I've had the easiest time setting up Wireshark, but all of the sniffers listed have been tested.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode