cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
382
Views
0
Helpful
5
Replies

Call conferencing doesn't work

julienf28
Level 1
Level 1

We have CCM 3.3 (i know, we are upgrading to the newer version of 7.X soon) and when we try to do a call conference with 3 people in the office, it just doesn't work. What service in CCM is this using?

5 Replies 5

Jaime Valencia
Cisco Employee
Cisco Employee

IPVMS, try resetting the CFB from GUI, if it doesn't work bounce the service. I'm assuming you're using SW CFB, for HW CFB you might try no sccp/sccp

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

cisco_goh
Level 1
Level 1

In version 6.0, i restart the service “Cisco IP Voice Media Streaming App”.

nwkotze
Level 1
Level 1

Enable CallManager detailed trace, you should find "out of resource" or simulator message.

Conferencing resource can be configured as a profile on the Voice Gateway if you have enough DSP resource. How to find out?

Do the "Max sess ?" under the "dspfarm profile 1 conference", you only need one!!

You can also do a "sho inv" - look at PBDM's.

voice-card 0

dspfarm

dsp services dspfarm

!

dspfarm profile 1 conference

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

codec g729r8

codec g729br8

conference-join custom-cptone jointone

conference-leave custom-cptone leavetone

associate application SCCP

Max sess ?

!

sccp ccm group 500

bind interface GigabitEthernet0/1.5

associate ccm 500 priority 1

associate profile 1 register GW-CNF

!

sccp local GigabitEthernet0/1.5

sccp ccm 10.41.5.1 identifier 500 version 4.1

sccp

!

Now add "Hardware conferance bridge" "GW-CNF" in CallManager and add to Resource Group for phones. Restart CallManager.

After Restart check CFB registration, and test.

If you still have problems add the transcoding profile using the same procedure you used for conferencing:

dspfarm profile 2 transcode

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

codec g729r8

maximum sessions 3

associate application SCCP

Figured out that the conference bridge isn't registered to the CM. what I need now is the correct syntax in the VGP to reset the PVDM DSPfarm. Anybody can help?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: