07-16-2009 03:58 AM - edited 07-03-2021 05:49 PM
I'm trying to install the WiSM in a 6509-E switch. There will be no connection between Sup720-3B and WisM. The Service Port is not getting ip address bij DHCP scope on 6509 switch.
wism service-vlan 51
wism module 8 controller 1 allowed-vlan 50,51,64,66,68,70,72,74,76,78,80,82,84
wism module 8 controller 1 allowed-vlan 86,88,90,92,94,96,98,100,102,128,130
wism module 8 controller 1 allowed-vlan 132,144
wism module 8 controller 2 allowed-vlan 50,51,64,66,68,70,72,74,76,78,80,82,84
wism module 8 controller 2 allowed-vlan 86,88,90,92,94,96,98,100,102,128,130
wism module 8 controller 2 allowed-vlan 132,144
wism module 8 controller 1 native-vlan 51
I configured a layer 2 and layer 3 VLAN 51 and assigned ip address to the SVI..
Service Vlan : 51, Service IP Subnet : 10.200.51.1/255.255.255.248
WLAN
Slot Controller Service IP Management IP SW Version Status
----+-----------+----------------+----------------+-----------+---------------
8 1 0.0.0.0 0.0.0.0 Service Port Up
8 2 0.0.0.0 0.0.0.0 Service Port Up
Also Session slot 8 pro 1 is not possible..
What can be wrong ?
Regards
Remco
07-16-2009 05:02 AM
have you enabled dhcp on the 6509?
service dhcp
Session slot 9 pro 1 will not be possible until you can assign it an ip address
07-16-2009 05:06 AM
Service DHCP is enabled (by default)...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: