Netconfig question

Answered Question
Jul 16th, 2009
User Badges:

Hi,


I know how to do mass config changes using netconfig jobs. However i would like to add a line on all our L3 VLANs. The change is to add an ip-helper address to all VLANs. The VLANs are saved in our core 6500.


The question is how do you make mass changes to a VLAN?? it is easy to do for devices but is it possible to do it for VLANs?

Correct Answer by Joe Clarke about 7 years 10 months ago

This is doable in RME 4.3 (part of LMS 3.2). A new feature was added which allows you to deploy mass configuration changes to ports and modules as well as devices. You can create a rule to match ports with a description containing vlan. Then, create an ad hoc task to set an ip helper-address on those ports. I just tested this, and it works.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Joe Clarke Thu, 07/16/2009 - 07:07
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

This is doable in RME 4.3 (part of LMS 3.2). A new feature was added which allows you to deploy mass configuration changes to ports and modules as well as devices. You can create a rule to match ports with a description containing vlan. Then, create an ad hoc task to set an ip helper-address on those ports. I just tested this, and it works.

Actions

This Discussion