Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
469
Views
0
Helpful
2
Replies

IP Load Balance

dkirby
Level 1
Level 1

‎07-16-2009 06:52 AM - edited ‎03-04-2019 05:27 AM

We have 2 FTP servers each in there own DMZ on two different physical sites, we want to be able to advertise 1 IP/FQDN to the internet. The two sites are connected by iBGP.

We could either cluster the firewalls so that we nat the DMZ FTP server address to one public address or we could use load balancers (which seems a slight overkill)

Does anyone have any other suggestions on how we would achive this

Many Thanks

Labels:
0 Helpful
2 Replies 2

smahbub
Level 6
Level 6

‎07-22-2009 05:33 AM

To use load balancing, configure the following elements for each device that participates in the cluster.

• Public and private interfaces

• VPN load-balancing cluster attributes

http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/vpnsysop.html#wp1048959

0 Helpful

dkirby
Level 1
Level 1
In response to smahbub

‎08-25-2009 02:23 AM

Thanks for your comments but (dare I say it) we are using checkpoint firewall, so I was hoping to do it on the public facing routers?

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card