kwillacey Thu, 07/16/2009 - 10:28
User Badges:
  • Bronze, 100 points or more

Check if your interfaces are up with the 'show interface' command. Chances are your speed is the problem either set them both to auto or hard code them both.

Jon Marshall Thu, 07/16/2009 - 10:30
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Arjun


Couple of things -


1) make the speed and duplex match on each end. So on router


int fa0/0

speed 100


2) If you have connected the router directly to the pix ie. no switch in between, then you need to use a crossover cable.


If you use a switch in between then you can use straight thru cables for both the router and the pix.


Jon

Actions

This Discussion