Config Help on Dial Peer

Unanswered Question
Jul 16th, 2009
User Badges:

Hello Everyone,


I have a PRI coming in on a 2800 series router and I need to send certain numbers that come in over to another router that has FXS ports connected to it. Can someone send an example of a dial-peer that will do that along with anything else I need to make that work?



Thanks in advance. All replies rated

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Kenneth Mohammed Thu, 07/16/2009 - 11:48
User Badges:
  • Silver, 250 points or more

Hello,


On the router with the PRI


dial-peer voice 100 voip

destination-pattern xxxx -(number you want to send to remote router)

session target ipv4:x.x.x.x (ip of remote router)

no vad


On the remote router:


dial-peer voice 200 pots

destination-pattern xxxx (ext of fxs port)

port x/x/x (fxs port)


Hope that helped, if so please rate


angel-moon Thu, 07/16/2009 - 12:52
User Badges:

Thanks Kenneth!



Is there any way to get the inbound caller ID over to the FXS port so that it shows up when the call is completed? It is working but the caller ID is not showing up

angel-moon Thu, 07/16/2009 - 13:06
User Badges:

As a second request we also need to configure a dial-peer that will send calls that originate from the second router over to the the first router with the PRI and then out to the PSTN.

Kenneth Mohammed Thu, 07/16/2009 - 13:34
User Badges:
  • Silver, 250 points or more

Hello,


For the caller id, try adding the command "caller-id enable" under the fxs port configuration.


For the second issue:


dial-peer voice xxx voip

destination-pattern (pattern for outbound calls)

session target ipv4:x.x.x.x (ip of PRI router)

no vad


On the PRI router, im assuming you already have an outbound pots dial peer that can be used.


Hope that helped, if so please rate.

Actions

This Discussion