Band-Select in

Unanswered Question

Is anyone successfully using Band-select ? I was reading the 6.0.182 release notes and found this comment:

"Band Select and Load Balancing CLI Commands

The config band-select and config wlan band-select CLI commands appear in controller software

release, but they are not supported and should not be used. Also, you can ignore the Band

Select Stats information in the output of the show ap stats {802.11a | 802.11b} Cisco_AP command."

Link to the release notes(page 22):

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode