cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
225
Views
0
Helpful
2
Replies

Communication between Router 2801 and Switch 2960

rodrigo-chagas
Level 1
Level 1

Hi, í would like to know if i have to set the speed at the fastethernet of these 2 equipments, or keep them in auto negociation. Thanks.

2 Replies 2

Jon Marshall
Hall of Fame
Hall of Fame

Rodrigo

Just be consistent on both ends.

So if you go auto on the 2801 do the same on the 2960. If you set the speed/duplex on the 2801 set it the same on the 2960.

Jon

Leo Laohoo
Hall of Fame
Hall of Fame

Newer generation of Cisco products have better speed/duplex autonegotiation with each other. Just to test, boot one and check with the other that the speed and duplex is full/100 instead of half/100 or half/10.

Otherwise, like what Jon said, force BOTH sides.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: