out of band management using pots line

Unanswered Question
Giuseppe Larosa Sat, 07/18/2009 - 04:32
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Joseph,

if you want to implement an out of band management for emergency to be used only when needed you need to use dial on demand routing.


you can find the basis of DDR in 12.4 dial config guide


http://www.cisco.com/en/US/docs/ios/dial/configuration/guide/dia_preparing_ddr_ps6350_TSD_Products_Configuration_Guide_Chapter.html


for the WIC-1AM-V2 it has a built-in analog POTS modem


follow the following document


http://www.cisco.com/en/US/docs/ios/12_3t/12_3t14/feature/guide/gt12pwi8.html#wp1053415


as you can see from router point of view it is seen as an interface Asynch.


you will use a separate address plan for out of band management so that the device can be reached = called or it can call the NOC center

a floating static route completes this scenario using PPP authentication and call screening (specifying the calling number that can be accepted)


Hope to help

Giuseppe



pompeychimes Sat, 07/18/2009 - 22:31
User Badges:
  • Bronze, 100 points or more

Just an opinion but to be truely OOB I like to use eternal modems.

Actions

This Discussion