cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
841
Views
4
Helpful
7
Replies

OSPF lab help.

Lijesh NC
Level 1
Level 1

Hi,

I am trying to set up an OSPF lab for running 5 Modes of ospf Operation.I am confused how can i make a framerelay cloud to run this.Can some some help me to achive this.

Thanks in advice

Lijesh

7 Replies 7

jimmysands73_2
Level 5
Level 5

When I was doing my NetAcad and trying to get ospf working over fr, I had to use the commad ip ospf network broadcast before my ospf routes were sent. I think. Eventually I got the FR working with OSPF though.

If you would post alittle bit more info, I'd be happy to look it over.

Reza Sharifi
Hall of Fame
Hall of Fame

I am not sure if I understand the question

Are you trying to build a frame relay cloud?

If yes, then you need a router like a Cisco 2522 as your frame relay switch.

Then you connect all your serial cables from all the other routers to this

Switch/router to simulate frame relay

HTH

Reza

hi sharif,

Thanks for the reply ..yes you are right . i am trying to build a frame relay cloud ..can i know the config (frame-relay cloud )can i achive this by dinamips ..

hitesh_patel
Level 1
Level 1

Hi Lijesh,

you need any low end cisco router with four or more serial interfaces to fit to your topology. You can have 2522 with 10 serial interfaces or can have any 2600 with NM-4AS or NM-8AS card. The rest is easy to configure it as frame relay switch. Here is the link which shows how to configure.

http://www.thebryantadvantage.com/Frame%20Relay%20Switch.htm

Regards,

Hitesh Patel

Hi Hitesh,

Thanks for the reply this was what i was loolkig for.will i b able to achive using dinamips ... any way i will give an try and let you know the status ...

lijesh

Hi hithesh,

Thank you so much i had tried (http://www.thebryantadvantage.com/Frame%20Relay%20Switch.htm ) and was able to do ..but can i run ospf on this topology if so what all changes need to be done in FR Swtich/Routers.Kindly help ..

Thanks in advance

Lijesh NC

If you were trying to do this for a class, I would suggest you try it on your own, then post what issues you are having. For starters:

http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a008009470d.shtml

http://supportwiki.cisco.com/ViewWiki/index.php/How_to_configure_OSPF_over_Frame_Relay

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco