cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1986
Views
0
Helpful
6
Replies

Is CSCsr89144 fixed on ASDM 6.1(3)

mikedelafield
Level 1
Level 1

I have just run in to this ridiculous ASA bug where ASDM stops working if uptime is over 1 year.

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCsr89144

Could someone please tell me if CSCsr89144 is fixed in ASDM 6.1(3) as this is the version I have in most sites?

I cannot find a definite answer.

6 Replies 6

Jerry Ye
Cisco Employee
Cisco Employee

Hi Michael,

It is not fixed in 6.1(3). It will be fixed in 6.1(5) and later release.

HTH,

jerry

Thanks for the quick reply.

Does ASDM 6.1(5) operate okay with ASA image 8.0.4?

Thanks.

Hi Michael,

I have not test it personally. I think you might want to install it in a small set of ASA's and test it.

Regards,

jerry

Thanks again.

I have a spare and I will test.

I cannot believe there is no other way around this bug!

Mike

Could someone please tell me if I only change the ASDM image path does the device need a reboot?

I presume the device continues operating normally and it only affects the ASDM GUI itself?

The next time I open ASDM will it should then open with the new image? I hope?

Thanks.

Hi Michael,

You have to reboot the ASA after you install the ASDM.

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a008067e9f9.shtml#maintask2

HTH,

jerry

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: