Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
519
Views
0
Helpful
1
Replies

Route Map - ASA 5540 - 2 ISP

j_Pearcy00
Level 1
Level 1

‎07-20-2009 08:09 AM - edited ‎03-04-2019 05:29 AM

We have 2 ASA 5540's in active passive failover connected to one of our ISPs. We have other firewalls that have another ISP as their gateway. We want to consolidate and run both ISPs on the ASA 5540s. What I want to do is use the IP address' from the one ISP for our servers that need to be accessible from the outside. What I want to know is will route-map be the best way to achieve this other than BGP? On the Inside interface of the ASAs there is a Procurve Layer 3 switch that will be the gateway of all of the servers, and the layer 3 switch has the ASAs as its default route. Thanks in advance

Labels:
0 Helpful
1 Reply 1

mmacdonald70
Level 1
Level 1

‎07-23-2009 03:37 AM

ASA can not do policy based routing or BGP. If the procurve can to PBR, you could set up the two ASAs in Active/Active and use one context for one ISP and the other context for the other.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card