Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
249
Views
0
Helpful
1
Replies

LACP on CAT 6500

mohammedrafiq
Level 1
Level 1

‎07-20-2009 08:35 AM - edited ‎03-06-2019 06:51 AM

Hi,

Our cat 6509 has many port channel configured with channelprotocol as PAGP, now we would like to enable LACP on few ports to bundle them in channel, by ebabling LACP on 6509 as below

"set channelprotocol lacp 6"

Will this effect the exsisting port channels pagp on module 6?

Regards,

Labels:
0 Helpful
1 Reply 1

Edison Ortiz
Hall of Fame
Hall of Fame

‎07-20-2009 09:22 AM

Yes, it will.

Based on the config guidelines:

All ports in an EtherChannel must use the same protocol; you cannot run two protocols on one module.

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/catos/8.x/configuration/guide/channel.html#wp1039836

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card