why con't setup tunnel between PEs?

Unanswered Question
Jul 20th, 2009
User Badges:

hi,i have a problem about multicast for mpls vpn.


at the core use ssm .but i don't know how to config P.the configuration of Pe:

ip multicast-routing

ip vrf a

rd 100:1

route-target both 100:1

mdt default

ip multicast-routing vrf a

ip pim ssm default

the configuration of P:

ip pim ssm default.

but display of the PE:

sho ip pim vrf a nei

only have the interface connect with CE .

why don't setup PEs ?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Tom Yan Mon, 07/20/2009 - 21:00
User Badges:

i want to know how to config the P.thans !

jon.harald.bovr... Mon, 07/20/2009 - 21:50
User Badges:


ip multicast-routing

ip pim ssm default

Interface config:

ip pim sparse-mode (on all relevant P and PE interface)

You might also need to enable 'address-family ipv4 mdt' on P/PE, dependent of HW/SW

A verification: show ip pim neigh on PE should show P-router as neigbour

Tom Yan Wed, 07/22/2009 - 19:27
User Badges:

i try to it.it maybe unused.thanks a lot!

Tom Yan Wed, 07/22/2009 - 20:03
User Badges:

thank you very much!i have make it well.


This Discussion