Spanning Tree on Radio sub interface

Unanswered Question

Hi,

I have a 1801 ADSL router.

I have a Bridge group 2 configure with a BVI interface, this is also bridge onto VLAN 2 so I have a server on VLAN 2 which acts as a media server.


when I connect to the WLAN I can get to the internet. But cannot connect to the server which is on the same vlan. when I do a show spanning tree I can see it is disabled on the dot11radio0.2 interface.

I remove the bridge-group 2 spanning disable and sure enough everything works.


on reboot spanning tree is disabled again.


Should I be doing this a bit differerntly to joing vlan 2 and the radio interface?


any ideas.


Regards

John



Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode