cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
451
Views
0
Helpful
1
Replies

WCS/WLC Disabled WLAN still broadcasts! BUG?

chris.brunt
Level 1
Level 1

Versions 6.0.182.0 on controllers (4 WISMs) and 6.0.132.0 on WCS.

Created a test WLAN which was used for a week or so, WPA2/PSK, broadcast ssid, standard stuff. I no longer wish to use it and set the enabled state in the template to disable and then saved and applied the template to the controllers. On various devices, I can still see it broadcasting! I have even checked on the individual controllers and the WLAN is set disabled, so no WCS sync issue. I also tried switching the broadcast ssid to off and reapplying it and this makes no difference.

If I try to connect to the WLAN, this fails, which is obviously a good thing! I have not tried to delete it yet as there are situations where we need the ability to enable/disable wlans.

Anybody else seen this issue before I report it to TAC?

1 Reply 1

ssoberlik
Level 4
Level 4

If the WCS and WLC has been synchronized, you should not see this issue. Since you have already verified and ruled out a sync issue, this looks like a bug.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: