Traffic QOS on router with OID

Unanswered Question
Jul 21st, 2009
User Badges:

Hi !

I monitor some routers with Nagios and I need to know the traffic of my QOS. I have found this two OID :




But, when I compare with my other plugin for Nagios which display the traffic in and out of my router I see that the traffic of my qos is just for the traffic_out.

I'm more interested in knowing what is the qos' traffic of my router for the traffic_in!

If there is another OID i'm interested because I haven't found it!

Thanks a lot,

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
yjdabear Fri, 07/24/2009 - 09:39
User Badges:
  • Gold, 750 points or more

Well, it depends on how you applied your QoS policies on the interface(s), e.g.:

Interface GigabitEthernet 10/1


service-policy [ output | input ] "policy-map-name"

magzz--69 Sun, 07/26/2009 - 23:18
User Badges:

When I use this oid : "policy-map-name" I have 2 responses :



so my output is "wan" and input is "ethernet".

But how can I find my Qos traffic for this TWO interfaces?

Thanks a lot for your answer :)

magzz--69 Mon, 07/27/2009 - 23:16
User Badges:

The result of the command is :

SNMPv2-SMI::enterprises. = STRING: "WAN"

SNMPv2-SMI::enterprises. = STRING: "ETHERNET"

But when I search the cbQosCMPostPolicyRate I have :

SNMPv2-SMI::enterprises. = Gauge32: 262000

SNMPv2-SMI::enterprises. = Gauge32: 0

SNMPv2-SMI::enterprises. = Gauge32: 0

SNMPv2-SMI::enterprises. = Gauge32: 6000

SNMPv2-SMI::enterprises. = Gauge32: 271000

And this is only for the traffic out

How can I use my previous values (1063 and 1073) to get the traffic in of my qos?

rtjensen4 Thu, 07/30/2009 - 07:39
User Badges:
  • Bronze, 100 points or more

As yjdabear stated,

This depends on the direction you have the QoS applied. If the policy is applied outbound: service-policy out, then you will be given the QoS rate for outbound traffic. If your other interface doesn't have a QoS Policy applied to it, you're not going to get anything.


This Discussion