07-22-2009 07:48 AM - edited 03-11-2019 08:58 AM
So I am trying to upgrade a PIX 515E to 7.0 from 6.3. I blew away the config and plugged in a little 4 port switch into eth1 on the PIX and on the other side there is a laptop.
The laptop is 192.168.1.5 and I configured the PIX through the interactive prompts to 192.168.1.4. I cannot ping between the two.
Anything that I am doing obviously wrong here? Thanks all.
07-22-2009 07:49 AM
name the e1 interface as "inside" and enable it.
HTH>
07-22-2009 09:30 AM
Did that already.
eth1 "inside" is up and line protocol is up.
Any other ideas?
07-22-2009 10:20 AM
check the show arp on the pix, make sure the firewall on the PC is disabled.
If the above is OK - post the config, with the output of "show route" and "show interface"
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide