Report of call volume on H.323 FXO port

Unanswered Question
Jul 22nd, 2009

Would like to have reports (hourly,daily and weekly) of the utilization of the FXO ports in H.323 gateways. FXO ports are used for outgoing calling in gateways and there are E1 for incoming calls. Of course, I would like to have the data in report in smallest interval (says, 10 seconds) such that I can see how close for the ports to be used up.

From my understanding, the counter in RTMT, Cisco Call Manager > FXOPortsActive

it seems not to be correct when I compare to a particular gateway (Did I?). May be I need to tune the refresh interval.

And I don't know how to get a REPORT instead of e-mail alerts.

(I forgot if it can show by gateway. Will check tomorrow when I have access)

CAR Gateway summary report, Device Reports > Gateway > Summary

From the description, it seems ok.

(Need to check tomorrow if it shows hourly, daily)

The other counters in RTMT

Cisco H.323 > CallsActive

Cisco H.323 > CallsInProgress

and in CAR

Gateway Utilization Report

Device Reports > Gateway > Utilization

would not be useful as I only want call volume in FXO ports. (These counters will take other voice ports into account)

I just wonder if there is better option. (We have OM ...)

I am using CUCM 6.1.4-1000-10

TIA and I will rate :)

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
steven_chan Wed, 07/22/2009 - 18:00


RTMT, Cisco Call Manager > FXOPortsActive

CAR Gateway summary report, Device Reports > Gateway > Summary

both are not suitable.

We also have LMS here.

It seems to me there is no solution other than some commands in VG and send out the result periodically.


This Discussion