cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
327
Views
0
Helpful
2
Replies

Checking Access Point Temprature

desaikeyur
Level 1
Level 1

Is there debug ap "command" or some other command that can give me Access Point Temprature ?

I have a AIR-LAP1131AG-A-K9 that reboots every weekend when the AC is turned off and it gets hot.

Also while we are at debug ap "command" is there a document the list of IOS commands that can be used.

2 Replies 2

Leo Laohoo
Hall of Fame
Hall of Fame

Are you operating the AP as Autonmous or LWAP?

If LWAP, look at the logs of your controller.

ericgarnel
Level 7
Level 7

most likely not

per the OID tree, there doesn't seem to be an envmon for temp

see: http://tools.cisco.com/Support/SNMP/do/BrowseOID.do?local=en&translate=Translate&objectInput=1.3.6.1.4.1.14179.2.2.1.1

There is one for the controller though

perhaps a feature request in the future, especially for rugged APs

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: