Ws-x6182 T1 Controller Card config question

Unanswered Question
Jul 23rd, 2009

I just put a 6182 controller card in my Cat6500 - when I set the 10/0/0 timeslots I don't get a

interface Serial10/0/0:0 - Like I would normaly see from a controller card. They only thing I see is

interface Port-channel10

no ip address

controller T1 10/0/0

channel-group 0 timeslots 1-14

description XXXX


controller T1 10/0/1

channel-group 0 timeslots 1-24


controller T1 10/0/2


controller T1 10/0/3


The Port channel - show ? I am not familar with this can someone explain?

Port-channel10 is up, line protocol is down (notconnect)

Hardware is EtherChannel, address is 000d.662c.ea8a (bia 000d.662c.ea8a)

MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Auto-duplex, Auto-speed

input flow-control is off, output flow-control is unsupported

ARP type: ARPA, ARP Timeout 04:00:00

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Giuseppe Larosa Thu, 07/23/2009 - 21:29

Hello Gabrielle,

you mean you have a flexwan module installed? WS-6182

What type of port adapters is placed into the flexwan module you can check this with

sh diag

you can find here a list of supported T1 port adapters

int port-channel 10 is another object and it is related to etherchannels not to ports in slot 10:

>> Hardware is EtherChannel, address is 000d.662c.ea8a (bia 000d.662c.ea8a)

you can check etherchannel defined in this system with

sh etherchannel summary

Hope to help



This Discussion