07-24-2009 02:04 AM - edited 03-06-2019 06:55 AM
Hi,
on a 4500 I am currently trying to get the information how much power a connected poe ip phone uses.
I got the following command output:
show power inline gi1/1
Interface Admin Oper Power(Watts) Device Class
From PS To Device
--------- ------ ---------- ---------- ---------- ------------------- -----
Gi1/1 auto on 7.5 7.0 Ieee PD 2
Interface AdminPowerMax AdminConsumption
(Watts) (Watts)
---------- --------------- --------------------
Gi1/1 20.0 15.4
===================
show power inline police gi1/1
Interface Admin Oper Admin Oper Cutoff Oper
State State Police Police Power Power
--------- ------ ---------- ---------- ---------- ------ -----
Gi1/1 auto on none n/a n/a 3.2
It would be fine if somebody could explain exactly the following terms:
- Power from PS
- Power to Device -> amount of power the phone uses?
- Operational Power -> also the amount of power the phone uses?
- Admin Power Max
- Admin Power Consumption
Best Regards,
Thorsten Steffen
07-24-2009 02:26 AM
Your phone is pulling 15.4 watts of power but the port is allowing up to 20.0 watts.
07-24-2009 03:17 AM
That's not what I think.
In my eyes it pulls 3.2 watts which is the operational power shown in the second output. Further it's a class 2 device which afaik pulls not more than 6,49 watts.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: