07-24-2009 02:56 PM - edited 03-15-2019 07:06 PM
I have the following configuration for two e1 voice for router
controller E1 1/0
framing NO-CRC4
ds0-group 0 timeslots 1-15 type r2-digital dtmf dnis
ds0-group 1 timeslots 17-31 type r2-digital r2-compelled ani
cas-custom 0
country xxxxxxx
cas-custom 1
country xxxxxxx
debounce-time 20
release-guard-time 10
answer-signal group-a 6
dnis-digits min 3 max 3
answer-guard-time 200
description first E1
!
controller E1 1/1
framing NO-CRC4
ds0-group 0 timeslots 1-15 type r2-digital dtmf dnis
ds0-group 1 timeslots 17-31 type r2-digital r2-compelled ani
cas-custom 0
country xxxxxxx
cas-custom 1
country xxxxxxx
debounce-time 10
release-guard-time 10
reanswer-time 1000
answer-signal group-a 6
dnis-digits min 3 max 3
answer-guard-time 1
description second E1
The carrier tells me that see errors in the E1, how i can verify this?,
there are any command similar to the sh int s0/0 to allow see errors.
Someone might explain the configuration of the e1
07-24-2009 03:31 PM
Hi,
Some good sources of info:
E1 R2 Signaling Configuration and Troubleshooting:
http://www.cisco.com/en/US/tech/tk652/tk653/technologies_configuration_example09186a00800ad389.shtml
E1 Error Events Troubleshooting:
http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800f99bb.shtml
E1 Alarm Troubleshooting:
http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800a70f6.shtml
E1 PRI Troubleshooting:
http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800f9e3a.shtml
Hope it helps a little bit. Please rate if helps.
Best regards,
- Adrián.
07-24-2009 05:55 PM
Hi,
Somebody knows that the difference in configuration in the e1 controller?
controller E1 1/0
debounce-time 20
answer-guard-time 200
controller E1 1/1
debounce-time 10
answer-guard-time 1
reanswer-time 1000
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: