Solved: What Feature Set do I have ?

rvonknorring · ‎07-27-2009

Hi,

I have tried to find out what feature set I have in my 6506-E switch. In the Cisco Software Advisor ("Research Software") I can enter my image name (which is s72033-pk9s-mz.122-18.SXD7a.bin), but the result is just an error message.

Anybody knows how to find out ?

Thanks

Ragnar

Peter Paluch · ‎07-27-2009

Hello,

There is a wonderful tool called IOS Feature Navigator you can find at

http://cisco.com/go/fn

Here, click on the link "Search by Image" and then enter the full name of your image.

In your case here, your IOS's feature set is

IP W/SSH/3DES LAN ONLY

Give it a try :)

Best regards,

Peter

View solution in original post

Peter Paluch · ‎07-27-2009

Hello,

There is a wonderful tool called IOS Feature Navigator you can find at

http://cisco.com/go/fn

Here, click on the link "Search by Image" and then enter the full name of your image.

In your case here, your IOS's feature set is

IP W/SSH/3DES LAN ONLY

Give it a try :)

Best regards,

Peter

rvonknorring · ‎07-27-2009

Hi Peter,

That's just what I needed !

Thanks a lot.

Ragnar

Giuseppe Larosa · ‎07-27-2009

Hello Ragnar,

this is old naming convention

m = runs from RAM

z= zip compressed

k9 = 3DES capable

p = provider image

s: not sure about it

it should be roughly equivalent to advanced ip services 3DEs

Hope to help

Giuseppe

rvonknorring · ‎07-27-2009

Hi Giuseppe,

Thanks for the info.

Ragnar