cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
750
Views
0
Helpful
7
Replies

NAT Table Info

Yehey
Level 1
Level 1

I have two routers (RTRA & RTRB) setup on a frame relay network. RTRA acts as the primary while RTRB acts as the secondary. Both routers are using NAT. If connection to RTRA fails traffic would failover to the secondary, causing the NAT Table to populate.

My question is how long would the system store the NAT Table on RTRB if traffic was restored on the primary? Will RTRB maintain the NAT Table until the router was reloaded?

Thanks

7 Replies 7

Endwigast
Level 1
Level 1

configure ka stateful NAT para pag nag failover hindi maputol yung mga tcp connections due to nat repopulation :)

Yup pero hanggang gano kaya katagal ma store yun NAT Table sa system n walang traffic pag hnd configured with SNAT?

Pano mo nalaman n Pinoy ako :D

sa yehey na word :D

pag naka SNAT mag replicate yung NAT table mo sa kabilang equipment. naka mirror yun. so kung ano laman nung active router NAT table yun din laman nung backup router NAT table. hindi mag expire yung translation kse kung mini mirror lang nya yung laman galing sa active. naka SNAT ka pala? nasa pinas ka ba? nasa pinas ako e hehe

hehehe. Nsa pinas din ako pero hnd p kami implement ng SNAT. San ka work?

call center tol. ikaw? wala pala PM dito PM sana kita

add mko sa ym. cyril_abundo@yahoo.com.

na add na kita

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card