Natting on noswitch port interfaces?

Unanswered Question
Jul 27th, 2009
User Badges:

Is is possible to nat on an interface in non-switchport mode? I would need to be able to nat a few addresses on each interface. Is this possible on a 450X and or 650x chassis switch?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Jon Marshall Mon, 07/27/2009 - 08:19
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN


When you say a "non switchport mode" presumably you mean a routed port ie.

int gi1/0

no switchport

ip address x.x.x.x x.x.x.x

If so then yes as far as i know you can do this on a 6500 as it is just like any other L3 port.

On a 4500 no you can't because the 4500 doesn't support NAT.



This Discussion