cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
330
Views
5
Helpful
2
Replies

Natting on noswitch port interfaces?

Patrick.Beaven
Level 1
Level 1

Is is possible to nat on an interface in non-switchport mode? I would need to be able to nat a few addresses on each interface. Is this possible on a 450X and or 650x chassis switch?

2 Replies 2

Jon Marshall
Hall of Fame
Hall of Fame

Patrick

When you say a "non switchport mode" presumably you mean a routed port ie.

int gi1/0

no switchport

ip address x.x.x.x x.x.x.x

If so then yes as far as i know you can do this on a 6500 as it is just like any other L3 port.

On a 4500 no you can't because the 4500 doesn't support NAT.

Jon

Thanks for the info.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco