07-27-2009 08:18 AM - edited 03-06-2019 06:57 AM
Hi,
I was trying to convert a Sup2/msfc2 from hybrid to native IOS. the 12.2.18SXF image requires at least 64MB flash. However, at the rommon, it cannot detect the disk0: (which is a PCMCIA ATA disk). Is there a way to overcome this problem? does upgrading the rommon version help to detect disk0:?
Any help greatly appreciated.
Thanks
Eng Wee
07-27-2009 08:44 AM
Hello Eng Wee,
your understanding is correct:
>> Supervisor Engine 2 ROMMON version 7.1(1) or later supports the MEM-C6K-ATA-1-64M= (64 MB) PCMCIA ATA FlashDisk device. For more information, refer to the ROMMON Image Overview section of Release Notes for Catalyst 6000 Family Supervisor Engine 2 ROMMON Software.
see
or
http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015bfa6.shtml#req
Hope to help
Giuseppe
07-27-2009 08:48 AM
Is this a Cisco ATA card?
What is the rommon version?
07-27-2009 11:51 PM
Hi..
Thanks for all the reply.
my rommon version is 7.1(1).
I managed to get it working when i do the following
1. Down load a 12.2.18SXF image that is <20MB.
2.TFTP the image to a 20MB PCMCIA flash.
3.Boot the new image from the flash.
4.After bootup, format the 64MB PCMCIA ATA flash. TFTP the desired image into this 64MB flash.
5.Configure âboot system flash disk0:â¦â¦..â and wr mem.
6.Reboot the switch
7.The switch will try to bootup from the PCMCIA ATA flash. For my case, it made several attempts before it is able to bootup. See attached.
Rgds
Eng Wee
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: