07-27-2009 09:27 AM - edited 03-18-2019 10:28 AM
Hi,
I did the following configuration:
hostname Router
ip domain name infomicro.local
ip name-server 192.168.0.100
fax receive called-subscriber $d$
fax interface-type fax-mail
mta send server 192.168.0.100 port 25
mta send subject "Cisco FAX to Mail"
mta send postmaster nelson@infomicro.local
mta send mail-from hostname Router.infomicro.local
mta send mail-from username $s$
!
application
service fax-onramp flash:app_faxmail_onramp.2.0.1.3.tcl
!
interface GigabitEthernet0/1
ip address 192.168.10.130 255.255.255.0
duplex auto
speed auto
!
dial-peer voice 40 pots
service fax-onramp
incoming called-number 5551234
direct-inward-dial
!
dial-peer voice 41 mmoip
service fax_on_vfc_onramp_app out-bound
max-conn 5
destination-pattern 5551234
information-type fax
session target mailto:fax@infomicro.local
When I make a call to the 5551234 the call begin the ring and after 2 or 3 seconds the call is answered, but that is all, the fxo port where I'm connecting the incoming line bring up and immediatly close the channel, I mean, disconect the call.
My question is, what is wrong? what I'm forgetting?
Hope somebody can help me
Regards
Nelson
PS: sorry about my english
07-29-2009 09:05 AM
Hi Nelson
I haven't checked all your config but you're missing a POTS dialpeer to the FXO port. The FXO voice port should also have the "signal did" command because DID is not enabled by default (as far as I know).
Regards
Stefan
09-07-2009 08:41 AM
Hello,
I'm using a Cisco 3825 with Cisco Internetwork Operating System. Cisco IOS (tm) C3825 C3825-ADVIPSERVICESK9-M, The System version is 12.4(15)T7 / CME 4.1(0) and I try to configure a "T.37 Store and Forward Fax" but when I download the latest version of tcl script (app-faxmail-onramp.2.0.1.3.zip and app-faxmail-offramp.2.0.1.1.zip) and I put it on my router cannot do anything!!!.
And when I check how to solve this problem I found when I put in the CLI the command: "sh call application voice onramp_kywi" (onramp_kywi calls the script app-faxmail-onramp.2.0.1.3.zip) only have the next response:
Script Name : onramp_kywi
URL : flash:app-faxmail-onramp.2.0.1.2.tcl
Type : Service
State: Not Loaded
Life : Configured
Exec Instances: 0
Script Code Begin:
--------------------------------
--------------------------------
The same thing ocurs with the offramp script.
The most "worrying" part is when the command says about the script "State: Not Loaded"
Do you have any fix/solution to this problem???...I need urgent help.
Thanks!!
09-17-2009 03:44 PM
You need to reload the router to load the script.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: