does anyone have any documentation for a Cisco 2811 router with a VWIC2-1MFT-T1/E1 card? I am trying to figure out how to configure a data t1 link. With this particular WIC, i do not have the Interface Serial command.
Rob has pointed you in the right direction. You need to start with the card type command. After you define the card type you need to configure the controller as Rob shows. Then you probably need to configure time slots to initialize your serial interface. It might look something like: channel-group 0 timeslots 1-24. It would then initialize interface serial0/1/0:0 which you can then configure.
You need to use the "card type" command to specify the type of card, after that the interfaces will show up. See below:
Router(config)#card type ?
Router(config)#card type t1 ?
<0-2> Card slot number (always 0 for 1800 series & 2801 routers)
Router(config)#card type t1 0 1
Router(config)#controller t1 ?
<0-0> Controller slot number
Router(config)#controller t1 0/1/0