07-27-2009 01:07 PM - edited 03-11-2019 08:59 AM
Ihave two ASA 5520, I am new to ASA as a fail over, I would like to know how I can view if the two firewalls states and which firewall is active
Solved! Go to Solution.
07-27-2009 02:04 PM
show failover
07-29-2009 01:18 PM
Shane
"sh mode" shows you which mode the firewall is running in.
To switch between firewalls either
1) on the current standby firewall use the command - "failover active"
OR
2) on the current active firewall use the command - "no failover active"
http://www.cisco.com/en/US/docs/security/asa/asa72/command/reference/ef_72.html#wp1759150
Jon
07-27-2009 02:04 PM
show failover
07-29-2009 12:54 PM
thanks that works, how do I change over to the primary firewall, and what command I use to see the mode the two firewall is running in?
07-29-2009 01:18 PM
Shane
"sh mode" shows you which mode the firewall is running in.
To switch between firewalls either
1) on the current standby firewall use the command - "failover active"
OR
2) on the current active firewall use the command - "no failover active"
http://www.cisco.com/en/US/docs/security/asa/asa72/command/reference/ef_72.html#wp1759150
Jon
07-29-2009 03:06 PM
Thanks a lot, for some reason I was not able to failover, when I went to the data center I saw that one of the firewall was off.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: