I searched this site, UC500.com, and cisco for any installation guides setting up a Qwest PRI circuit on the UC500, and specifically on the VWIC2-1MFT-T1/E1=
We're always doing Cbeyond SIP circuits and now we have a Qwest PRI circuit.
Does anyone have the set up guide/seps /procedure for this card on the UC500 ?
I'd love any guides, advice, look out for these gotchas, etc
Eivind is correct. CCA should get you there.
I´ve found that the setup is easy using CCA. The one thing I ended up struggling with was a CRC setting from the telco. Other than that it was "a walk in the park" (is that the correct term?!)
You can take a look at my post when I setup my first UC with a VWIC card;
Message was edited by: Eivind Jonassen