Solved: UC500 with Qwest PRI - looking for guides

stacy.thompson · ‎07-28-2009

I searched this site, UC500.com, and cisco for any installation guides setting up a Qwest PRI circuit on the UC500, and specifically on the VWIC2-1MFT-T1/E1=

We're always doing Cbeyond SIP circuits and now we have a Qwest PRI circuit.

Does anyone have the set up guide/seps /procedure for this card on the UC500 ?

I'd love any guides, advice, look out for these gotchas, etc

Thanks!

Stacy

Eivind Jonassen · ‎07-28-2009

Hi Stacy,

I´ve found that the setup is easy using CCA. The one thing I ended up struggling with was a CRC setting from the telco. Other than that it was "a walk in the park" (is that the correct term?!

)

Regards

Eivind

You can take a look at my post when I setup my first UC with a VWIC card;

https://www.myciscocommunity.com/message/8911

Message was edited by: Eivind Jonassen

View solution in original post

Marcos Hernandez · ‎07-28-2009

Stacy,

Eivind is correct. CCA should get you there.

Thanks,

Marcos