Point to Point

Unanswered Question
Jul 28th, 2009
User Badges:

Hello,



On a point to point connection on the serial interface when I do a show service-module I am getting:


Transmitter is sending remote alarm.

Receiver has loss of signal, loss of frame,

Framing is ESF, Line Code is B8ZS, Current clock source is line,



Does this look like a Telco problem or a config problem? CUrrently the serial interface has an IP address but is showing down/down even after a no shut.



Thanks in advance. ALl replies rated!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
pciaccio Tue, 07/28/2009 - 12:38
User Badges:
  • Silver, 250 points or more

This indication is telling you that you are not seeing any signal input to the router. You probably have a wiring issue from the telco demarc point (handoff) to your router T-1 interface. I would verify connectivity on your infrastructure...

Actions

This Discussion