AP IOS upgrade and can't associate ?

Unanswered Question
Jul 28th, 2009
User Badges:

Hi NetPro,


After IOS upgrade , this AP can not Associate anymore.


Previous IOS version : flash:/c1240-k9w7-mx.123-7.JA5/c1240-k9w7-mx.123-7.JA5


Proposed IOS Version : c1240-k9w7-tar.124-10b.JDA3.tar


AP Model : AIR-AP1242AG-E-K9


Interface IP-Address OK? Method Status Protocol

BVI1 10.68.151.15 YES NVRAM up up

Dot11Radio0 unassigned YES NVRAM initializing down

FastEthernet0 unassigned YES NVRAM up up


P/S : Radio keep initializing status .


your reply will be highly appreciated.


thanks a lot.


Jack

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3.5 (2 ratings)
Loading.
George Stefanick Tue, 07/28/2009 - 21:15
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, October 2015

Hummm... check the power on the radio.

dancampb Wed, 07/29/2009 - 07:01
User Badges:
  • Cisco Employee,

Looks like the radio firmware didn't get loaded correctly. Try manually reloading the firmware with the following command:


dot11 dot11Radio 0 recovery-fw flash:c1240-k9w7-mx.124-10b.JDA3/6701.img


Then reload the entire image again. If that doesn't do the trick you'll probably need to RMA the AP.


Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode