07-28-2009 07:04 PM - edited 07-03-2021 05:53 PM
Hi NetPro,
After IOS upgrade , this AP can not Associate anymore.
Previous IOS version : flash:/c1240-k9w7-mx.123-7.JA5/c1240-k9w7-mx.123-7.JA5
Proposed IOS Version : c1240-k9w7-tar.124-10b.JDA3.tar
AP Model : AIR-AP1242AG-E-K9
Interface IP-Address OK? Method Status Protocol
BVI1 10.68.151.15 YES NVRAM up up
Dot11Radio0 unassigned YES NVRAM initializing down
FastEthernet0 unassigned YES NVRAM up up
P/S : Radio keep initializing status .
your reply will be highly appreciated.
thanks a lot.
Jack
07-28-2009 09:15 PM
Hummm... check the power on the radio.
07-29-2009 07:01 AM
Looks like the radio firmware didn't get loaded correctly. Try manually reloading the firmware with the following command:
dot11 dot11Radio 0 recovery-fw flash:c1240-k9w7-mx.124-10b.JDA3/6701.img
Then reload the entire image again. If that doesn't do the trick you'll probably need to RMA the AP.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: