07-29-2009 11:49 AM
Hello, i need to set up syslog in RME 4.0.6.
Is there any tutorial or a guide to do that?
Thanks
07-29-2009 11:58 AM
Set it up how? Do you want to enable syslogging on the devices, or enable RME to receive syslog messages?
07-29-2009 12:09 PM
Enable the RME to receive syslog messages. The devices has already been enabled
07-29-2009 12:16 PM
Nothing needs to be done. RME will listen for syslog messages by default. The messages will be written into NMSROOT\log\syslog.log on Windows. From there, they will be filtered, and inserted into the RME database so that you can run reports.
07-29-2009 12:24 PM
The RME was installed 3 mounth ago and the NMSROOT\log\syslog.log has 3 Gb of data but when i run the reports, they always are empty. i dont know if there's some filted enabled.
07-29-2009 12:27 PM
Post a screenshot of RME > Tools > Syslog > Message Filters.
07-29-2009 12:43 PM
07-29-2009 12:55 PM
This looks okay. Note, that section of the RME Homepage only tracks the most severe messages. I don't know what the c6k filter is, but I'm betting you don't have any S0, S1, or S2 messages. Instead, go to RME > Reports > Report Generator, and run a syslog standard report for all of your devices. What do you get? How is the c6k filter defined? What messages do you see in syslog.log?
07-29-2009 01:19 PM
07-29-2009 01:28 PM
Okay, this is wrong. I think what you really want is:
Facility : *
Severity : *
Mnemonic : *
Description : *
Try modifying your filter, then send some more syslogs, and they should show up in your reports.
07-30-2009 05:24 AM
Thank you jclarke. You were right, that was the problem, now it is working fine.
Regards
Oscar
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: