cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
401
Views
0
Helpful
3
Replies

CCME 4.0 on a 2811 interfacing with a Ericsson MD110

abrashic
Level 1
Level 1

Currently have a 2811 running CCME 4.0 and would like to interface with an Ericsson MD110 using E1 QSIG. Does anyone have an example that I could start looking at.

1 Accepted Solution

Accepted Solutions

This happens all the time.

Once you become familiar with the meaning of "debug isdn q931" you're able to adapt to almost any situation.

Please remember to rate useful posts with the scrollbox below!

View solution in original post

3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

Just set switch type and you will be working. Then for additional features, see case by case.

Would be worth to update CCME because 4.0 is old already.

Thanks. I was trying to support some team members in a less perfect environment. My config was good but they were given incorrect telephone access #s and only partial E1 trunk access.

This happens all the time.

Once you become familiar with the meaning of "debug isdn q931" you're able to adapt to almost any situation.

Please remember to rate useful posts with the scrollbox below!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: