Teleworker UC520 / SR520

Unanswered Question
Jul 29th, 2009
User Badges:

Hi i recently had a new UC520 system installed and my installer is having a terrible time (as am i) getting teleworker installed. i have opened numerous tickets with Cisco and its seems no one has the complete answer. Does anyone have any detailed information to set this up ? Can this be done via a GUI ? any information would be appreciated.


Thank you

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Thu, 07/30/2009 - 13:41
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Forget the GUI, professional configuration is done with CLI exclusively.


Key to success is having a proper VPN setup.


Then, you want to mention the specific problem here with full details. Be reassure lot of people uses remote phones without any problem.

paolo bevilacqua Thu, 07/30/2009 - 16:16
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

To be honest with you, documentation is a bit confusing, because there are hundreds different ways to configure a VPN including certain cases in which a non-cisco VPN is used.


In any case, once you have the VPN 100% working, then it's just a matter of installing IPCP on a PC and registering as a ephone into CME.


You can also consider hiring a professional for the VPN job that is crucial.

Actions

This Discussion