Remember that the DSPs on a single PCB (the motherboard is one PCB, each NM is a separate PCB) are capable of being synchronized with only a single clock source. You may experience clock slips if the PRIs using the same DSPs have multiple clock sources.
Again, the 3826 is not the right box for 10 PRIs. If it was, cisco would have have put slots for card and dsp directly on the mother and directly without using NMs,m that is a kludge.
Then if you like to meet failure first person, do as you please.
For this PRI density, you best choice is to go directly to an AS series box like 5400XM.
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
